博文
Module 9 Exam - CCNA 1(2007-05-15 20:00:00)
摘要：
Take Assessment - Module 9 Exam - CCNA 1 Networking Basics (Version 3.1)
Time Remaining:
1
Refer to the exhibit. Which two statements are correct in reference to the output shown? (Choose two.)
The LAN segment is subnetted to allow 254 subnets.
The DNS server for this host is on the same subnet as the host.
The host automatically obtained the IP addresses 192.168.1.100.
The host received the IP address from a DHCP-enabled device on the local LAN segment.
The host is assigned an address of 00-50-8D-F1-EA-8D by the administrator.
2
Refer to the exhibit. The small office LAN shown in the exhibit may eventually be connected to the Internet. According to Cisco best practice, which IP network addresses should be used?
12.0.0.0
172.0.0.0
172.168.0.0
192.32.17.0
192.168.67.0
225.1.5.0
3
W......
Module 8 Exam - CCNA(2007-05-15 19:59:00)
摘要：
Take Assessment - Module 8 Exam - CCNA 1 Networking Basics (Version 3.1)
Time Remaining:
1
A network administrator has a multi-floor LAN to monitor and maintain. Through careful monitoring, the administrator has noticed a large amount of broadcast traffic slowing the network. Which device would you use to best solve this problem?
bridge
hub
router
transceiver
2
What is the function of a Layer 2 switch?
forwards data based on logical addressing
duplicates the electrical signal of each frame to every port
learns the port assigned to a host by examining the destination MAC address
determines which interface is used to forward a frame based on the destination MAC address
3
Refer to the exhibit. The switch and the hub have default configurations, and the switch has built its CAM table. Which of the ho......
Module 6/7 Exam - CCNA(2007-05-15 19:58:00)
摘要：
Take Assessment - Module 6/7 Exam - CCNA 1 Networking Basics (Version 3.1)
Time Remaining:
1
Which of the following are specified by IEEE standards as sublayers of the OSI data link layer? (Choose two.)
Logical Link Control
Logical Layer Control
Media Access Control
Logical Link Communication
Media Access Communication
Physical Access Communication
2
In an Ethernet LAN, how does the NIC know when it can transmit data?
An Ethernet NIC transmits data as soon as the frame is received.
An Ethernet NIC transmits data as soon as the NIC receives a token.
An Ethernet NIC transmits data when it senses a collision.
An Ethernet NIC transmits data after listening for the absence of a signal on the media.
3
Refer to the exhibit. Host A is communicating with host F. What happens to a frame sent from......
Module 7 Exam - CCNA(2007-05-15 19:57:00)
摘要：
Take Assessment - Module 7 Exam - CCNA 1 Networking Basics (Version 3.1)
Time Remaining:
1
How does 1000BASE-T use the UTP wire pairs to accomplish transmission?
two pairs are used to transmit and two pairs are used to receive
one pair is used to transmit, one pair is used to receive, one pair is used for clocking, and one pair is used for error correction
all four pairs are used in parallel by both hosts to transmit and receive simultaneously
two pairs of wires are used as in 10BASE-T and 100BASE-TX
2
Which RJ-45 pins are used to transmit and receive data in an Ethernet 100BASE-TX Category 5 UTP cable? (Choose two.)
1 and 2
3 and 6
4 and 5
7 and 8
3
What is the maximum distance that 10BASE-T will transmit data before signal attenuation affects the data delivery?
100 meters
185 meters
......
Module 1 Exam - CCNA(2007-05-15 19:56:00)
摘要：
Take Assessment - Module 1 Exam - CCNA 1 Networking Basics (Version 3.1)
Time Remaining:
1
What is the hexadecimal equivalent for the binary number 00100101?
15
20
25
30
37
40
2
Which of the following are popular web browsers? (Choose two.)
Acrobat
Internet Explorer
Macromedia Flash
Netscape Navigator
Quicktime
World Wide Web
3
What are three conditions that would require a network administrator to install a new NIC? (Choose three.)
whenever a NIC is damaged
when there is a need to provide a secondary or backup NIC
when there is a change from copper media to wireless
whenever operating system security patches are applied
whenever the PC has been moved to a different location
4
Represented as a decimal number, what is the re......
Module 2 Exam - CCNA(2007-05-15 19:55:00)
摘要：
Take Assessment - Module 2 Exam - CCNA 1 Networking Basics (Version 3.1)
Time Remaining:
1
What is the term used to describe the transport layer protocol data unit?
bits
packets
segments
frames
data streams
2
Refer to the following list. Choose the correct order of data encapsulation when a device sends information.
segments
bits
packets
data
frames
1 - 3 - 5 - 4 - 2
2 - 1 - 3 - 5 - 4
2 - 4 - 3 - 5 - 1
4 - 3 - 1 - 2 - 5
4 - 1 - 3 - 5 - 2
3 - 5 - 1 - 2 - 4
3
Which two features apply to WAN connections? (Choose two.)
operate using serial interfaces
make network connection using a hub
limited to operation over small geographic areas
typically operate under local administrative control
provide lower bandwidth services compared to LANs
......
Module 3 Exam - CCNA(2007-05-15 19:53:00)
摘要：
Take Assessment - Module 3 Exam - CCNA 1 Networking Basics (Version 3.1)
Time Remaining:
1
What factors should be considered when selecting the appropriate cable for connecting a PC to a network? (Choose two.)
type of system bus
motherboard model
distance of cable run
speed of transmission
computer manufacturer
2
What are two advantages of using UTP cable in a networking environment? (Choose two.)
is stiffer than STP
is less expensive than fiber
is easier to install than coaxial
provides longer distances than coaxial provides
is less susceptible to outside noise sources than fiber is
3
A company is converting a cabled LAN to a wireless Ethernet LAN. What must be changed on every host on the network?
No changes are required.
Each host will require a new IP address.
Each ......
Module 4 Exam - CCNA(2007-05-15 19:52:00)
摘要：
Take Assessment - Module 4 Exam - CCNA 1 Networking Basics (Version 3.1)
Time Remaining:
1
What factors need to be considered to limit the amount of signal attenuation in Ethernet cable runs? (Choose two.)
type of users
number of users
length of cable
type of electrical equipment
installation of connectors on the cable
2
A company needs to extend the LAN to six separate buildings. To limit the amount of signal attenuation on the LAN media, what type of media would be the best to use between the buildings?
air (wireless)
coaxial cable
fiber
shielded twisted pair
unshielded twisted pair
3
What is a cause of crosstalk in UTP cable?
cable pairs that are shorted
cable pairs crossed during termination
cabling runs installed in separate conduit
cable pairs that are untwiste......
Module 6 Exam - CCNA(2007-05-15 19:51:00)
摘要：
Take Assessment - Module 6 Exam - CCNA 1 Networking Basics (Version 3.1)
Time Remaining:
1
A router has an Ethernet, Token Ring, serial, and ISDN interface. Which interfaces will have a MAC address?
serial and ISDN interfaces
Ethernet and Token Ring interfaces
Ethernet and ISDN interfaces
Token Ring and serial interfaces
2
Refer to the exhibit. A technician wants to increase the available bandwidth for the workstation by allowing the switch and the NIC on the workstation to transmit and receive simultaneously. What will permit this?
CSMA/CD
full-duplex
FastEthernet
crossover cable
3
Which of the following are specified by IEEE standards as sublayers of the OSI data link layer? (Choose two.)
Logical Link Control
Logical Layer Control
Media Access Control
Logical Link Communicat......
Module 5 Exam - CCNA(2007-05-15 19:42:00)
摘要：
Take Assessment - Module 5 Exam - CCNA 1 Networking Basics (Version 3.1)
Time Remaining:
1
Which of the following are benefits of peer-to-peer networks? (Choose three.)
centralized security
easy to create
very scalable
no centralized equipment required
centralized administrator not required
centralized control of assets
2
What is the most common type of cabling used in LANs?
STP
UTP
coax
fiber
3
Which items in the exhibit are DTE devices?
A and B
B and C
C and D
A and D
A, B, C, and D
4
Which statement is accurate about a WAN link?
The link transmits data serially.
The link uses a maximum distance of 100 meters.
The link uses the same transmission rate as all other WAN links use.
The link uses the same standardiz......